ToolFusion

Compute calibrated Euclidean edge error

Compute calibrated Euclidean edge error.

Runnable This tool can run, but independent engineering verification has not been established.

Quick Answer

The compute calibrated euclidean edge error computes ε_mag from the input values you provide.

Calculator

ε_mag (mm)
—

ToolFusion Engineering Network

ToolFusion Engineering Network

Access thousands of engineering calculators, standards, and design tools. Join the ToolFusion network for comprehensive engineering resources.

Explore ToolFusion

Result Interpretation

Compute calibrated Euclidean edge error computes ε_mag in mm using the defined engineering formula and the input values provided. ε_mag is expressed in mm. No universal acceptance threshold is defined by this calculator.

Worked Example

default_test

Given:

  • s = 0.025
  • x_ref = 1028.7
  • y_ref = 765.9
  • x_edge = 1024.3
  • y_edge = 768.1

Expected Result:

  • ε_mag = 0.12298373876249

Engineering Interpretation:

Under the given input conditions, the calculated result is: ε_mag = 0.12298373876249 mm.

The actual numerical result is computed by the Runtime engine using the persisted tool definition. The values shown here come from deterministically validated test cases.

Formula / Method

ε_mag = s*sqrt(pow((x_edge-x_ref),2)+pow((y_edge-y_ref),2))

ε_mag.

Variables

SymbolLabelRoleDescription
x_edge x_edge INPUT x_edge
y_edge y_edge INPUT y_edge
x_ref x_ref INPUT x_ref
y_ref y_ref INPUT y_ref
s s INPUT s
ε_mag ε_mag OUTPUT ε_mag

Calculation Steps

  1. Enter the x_edge in pixel.
  2. Enter the y_edge in pixel.
  3. Enter the x_ref in pixel.
  4. Enter the y_ref in pixel.
  5. Enter the s in mm/pixel.
  6. Read the ε_mag (mm) from the results.

Frequently Asked Questions

What does this calculator calculate?

The Compute calibrated Euclidean edge error estimates ε_mag based on the input parameters you provide

Why is x_edge important in this calculation?

_edge is used directly in the calculation of ε_mag. Its effect on the result depends on the complete formula and the values of the other inputs.. When you enter x_edge in pixel, the calculator uses it in the engineering formula to compute the output

How should I interpret the result ε_mag?

The calculator outputs ε_mag in mm. The result is computed directly from the input values using the defined engineering formula

What units should I use for the inputs?

Enter each value in the units shown next to the input field: x_edge (pixel), y_edge (pixel), x_ref (pixel), y_ref (pixel), s (mm/pixel). Make sure all inputs use the specified units for consistent results

What assumptions does this calculator use?

This calculator uses automatically validated engineering formulas. Results are approximate and should be validated against site-specific conditions, applicable codes, and professional engineering judgment

Related Tools

Browse More Tools

Explore the full index of engineering calculators on this vertical site.